Fletch-Tite Platinum


Excellent adhesives for fletching vanes and feathers to wood, carbon, aluminum, or fiberglass shafts.

Flammable Material *

SKU: 1414 Category:


Fletch-Tite Platinum is an excellent adhesive for fletching all vanes and feathers. Can be used on wood, fiberglass, carbon, or aluminum shafts. This extremely durable adhesive is water repellent, flexible, and just gets stronger over time.

-Will adhere to any type of arrow shaft.
-Only requires five minutes in the clamp. Full cure in 48 hours.
-Gets stronger over time.
-3/4 oz. /22 gr.

Manufacturer Directions:

1-Properly clean arrow shaft.
2-apply thin bead of blue to fletching base. Allow the glue to dry in the jig for 5 minutes (clamp time).
3-Remove from jig and dot tip and tail of fletching with a small amount of glue (for added security).
4-Set aside for at least 48 hours (cure time). Do not allow vanes to rest flat on a surface until adhesive is fully cured. Let arrows rest with fletching hanging off the edge of a table or use Bohning arrow pads to prevent contact.

Manufacture tips for best use:

-Fletch arrows and allow to cure in a controlled climate with low humidity.
-Use a substantial amount of blue. It is ok if the glue beads up slightly around the base when fletched, but too much is unnecessary.
-Discard glue after 2 years and purchase new to ensure best adhesion properties.

Fletch-Tite Platinum is a flammable product and will not be shipped by air.

Customer Questions & Answers

There are no questions yet. Be the first to ask a question about this product.

Send me a notification for each new answer.